C0635 Skoda Auto Trouble Code

C0635 Skoda the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

Accelerator Pedal Position Sensor 1 Circuit Low and P2127 - Accelerator Pedal Position Sensor 2 Circuit Low would lead you to suspect a defective accelerator pedal position sensor.

C0635 Skoda Possible Solution:

Brake Switch Out of Self-Test Range Indicates that during Key On Engine Off (KOEO) Self-Test, BPP signal was high. Or during Key On Engine Running (KOER) Self -Test, the BPP signal did not cycle high and low. Open or short in (BPP) circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit (Rear Electronic Module [REM] Windstar and LS6/LS8 and Lighting Control Module (LCM) Continental and Town Car) Damaged Brake Switch Misadjusted Brake Switch Check for proper function of stoplamps. Follow correct Self-Test procedures, refer to Section 2, Quick Test.

C0635 Skoda Description For All Models :

C0635 Skoda Trouble Repair :

C0635 Skoda code shows that location the body harness connector, located in and around the left hand kick panel area or inside the IP (consult a shop manual for location). Water can leak into the connector from clogged sunroof drains, A-pillar leaks, or windshield or cowling leaks.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120